IKEA RIBBENAS Bedienungsanleitung Seite 10

ENGLISH
Installation
WARNING!
Before installing the appliance,
carefully read the safety information in this
booklet.
Installation checklist
Door
‰ Door seals completely to cabinet on all sides
‰ Door is level
Levelling
‰
Refrigerator is level
Electrical power
‰
Wait 4 hours
‰ House power turned on
‰ Refrigerator plugged in
Final checks
‰ Packing materials removed
‰ Refrigerator temperature set
Positioning
•
Follow the separate Assembly Instructions to
install this appliance.
•
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of the
appliance. This ensures the correct operation of
the appliance. Explanation of climate classes is as
follows:
Climate class Ambient temperature range
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
-
"SN" indicates that this refrigerating appliance
is intended to be used at ambient temperatures
ranging from 10°C to 32°C.
-
"N" indicates that this refrigerating appliance is
intended to be used at ambient temperatures
ranging from 16°C to 32°C.
-
"ST" indicates that this refrigerating appliance is
intended to be used at ambient temperatures
ranging from 16°C to 38°C.
-
"T" indicates that this refrigerating appliance is
intended to be used at ambient temperatures
ranging from 16°C to 43°C.
For some models of appliances, some functional
problems can occur when they operate outside
the specified temperature ranges. The correct
operation can only be guaranteed within the
specified temperature ranges.
If you have any doubts regarding installation,
please turn to the vendor, our customer service or
the nearest Authorised Service Centre.
Location
To ensure best performance, install the appliance well
away from sources of heat such as radiators, boilers,
and direct sunlight. Make sure that air can circulate
freely around the back of the cabinet.
Levelling the appliance
If the appliance tilts in some way, adjust the two feet
at the front of the appliance to level the appliance.
Refer to the separate Assembly Instructions for
detailed instructions.
1. Disconnect the mains plug of the appliance from
the power socket.
2. Turn the leveling screws clockwise to raise the unit,
turn counterclockwise to lower it.
Aligning the doors
If the fridge doors are not aligned, adjust the height
of the doors so that they are at the same level.
1. Make sure the appliance is disconnected from the
power supply.
2. Raise the lower door so that it is the level with the
higher door.
3. Using a pair of pliers, insert the supplied fastener-
ring into the gap between the hinge grommet and
the lower hinge. If needed, insert more fastener-
rings for height increase until both doors are
aligned.
Not level
Lower hinge
10
Hinge
grommet
Pliers
Fastener-ring