Elica NIKOLATESLA ONE PRF0120977A Montage- Und Gebrauchsanweisungen Seite 19

use, the symbol (9) is displayed
● Egg Timer
The Egg Timer function is a countdown independent of the
cooking zones (and the extraction zone). At the end of the
set time, the user is informed by way of an acoustic signal.
The Egg Timer can be activated by pressing
Note: to set the Egg Timer function, follow the same
procedure as that for the Timer function.
● Power Limitation
The Power Limitation function allows the product to be
used while limiting its maximum absorption, adjusting the
absorbed power in all active cooking zones, ensuring that
the total absorbed power of the hob does not exceed the
set maximum absorption level.
Note: the setting must be made with the hob switched off,
without pressing the ON/OFF (1) button, when the hob
is connected to the mains, or reconnected to the mains,
within the next 2 minutes.
To set the Power Limitation:
• press (6)
• while pressing and holding
(4)
• a short beep will sound
• while keeping pressed
(2-FL)
• at this point, it is possible to release the key
the Display (7) of the FL zone will show, in alternating
sequence, the symbols "
setting can be made.
the Display (7) of the RL zone will show the current setting:
Displayed value Power (Kw)
7.4 Kw (default setting)
3.1 Kw
4.5 Kw
To change the Power Limitation setting:
• press (2-FL)
- to save the selection, press
beep will sound to confirm the setting.
• press ON/OFF (1), to exit the function.
(5)
(6), press and release
(6), press and release
(6):
" and " " indicating that the
(4) for 2 seconds; a long
USING THE EXTRACTOR
● Power-on
Press (touch) ON/OFF (1) hob/extractor
The indicator light will turn on to indicate that the hob/
extractor is ready for use.
Press again to switch it off.
NOTE: this function has priority over all others.
● Switching the extraction system on
Touch (press) the selection key
extractor.
● Extraction speed (power):
Touch (press) the selection key
extraction speed (power) (0-10);
Touch (press) the selection key
extraction speed (power) (10-0);
● Timer
Activating the extractor fan Timer function:
The Timer is activated, from any speed, by pressing the
symbol (5)
display (10) shows the countdown; display (9) shows the
symbol .
Extractor fan Timer setting:
It is possible to change the preset switch-off times. The
variation must be made when the Timer is active.
• press (5), to increase the automatic switch-off time.
• press (4), to decrease the automatic switch-off time.
● Filter saturation indicator
The hood indicates when maintenance is needed for the
following filters:
Grease filter: the FILTER (11) LED lights up;
Activated carbon odour filter: the FILTER (11) LED flashes;
● Reset filter saturation
After performing maintenance on the filters (grease and/or
activated carbon), press and hold the key
FILTER (11) LED goes out. This resets the filter usage
counter.
● Activating/Deactivating the filter saturation indicator
light.
These indicators are normally deactivated (for both the
grease filter and the activated carbon filter)
19
(3) to activate the
(3), to increase the
(4), to decrease the
(6) until the