Ultrasport Ultra fit Jumper 251 Betriebsanleitung Seite 27

H. Jumper 251
Attach a spring to hole 4 of the corresponding eyeletand from there attach a spring every eight holes. For even distribution
of the tension and an easier assembly, each of the springs should be attached to the opposite sides of the mat/the frame,
28, 32, 36, 40, 44 and 48.
I. Now attach a spring every four holes or to the correspondingeyelets. For even distribution of the tension and an easier as-
sembly, each of the springs should be attached to the opposite sides of the mat/the frame.
J. Then attach all remaining springs by using the same method of counting down equal holes.
If you realize you have lost count, recount and remove or attach the necessary springs to obtain the necessary number of
springs.
Attaching the frame padding
Never use the trampoline without the frame padding attached Tie the frame padding down properly before every use!!
Make sure that the safety padding of the trampoline is securely positioned on the trampoline.
STEP 5
A. Lay the safety padding (#2) over the trampoline so that the springs and steel frame are covered. Make sure that the safety
padding covers all metal parts. Attach the elastic, as shown in FIGURE 8, by alternatingly arranging the elastic over the leg
base.
ELASTIC
!
CAUTION
!
WARNING
TRAMPOLINE PADDING
(RAISED)
LEG BASE
20, 24,
FIGURE 8