Ultrasport Ultra fit Jumper 251 Betriebsanleitung Seite 25

STEP 4 – Attaching the trampoline mat
A. Lay the trampoline mat (#1) in the frame. The UltraFit logo must face upwards as shown in FIGURE 5.
B. In total, Jumper 251 has 48 triangular rings sewn on to the map and 48 holes in the frame of the top bars. None of these
rings or holes are numbered. Please carefully follow the instructions to ensure correct assembly.
C. Choose a random point on the frame of the top bars (call it ZERO), as shown in FIGURE 5.
so please don't use violence. Once you have attached the hooks of the springs into the main frame, twist the springs in the
direction of the mat, as shown below. Use the specially enclosed tool to pull together the springs and the mat and attach
the hooks to the frame. Please note the zero point as you will later use this point to attach the springs.
INSTRUCTIONS TO TENSE THE SPRINGS
• Two adults are needed for this step.
• CAUTION – While attaching the springs, do not put your hands, legs or bodies
close to the connection points. The connection points can trap your hands as
the trampoline tenses.
• Wear heavy work gloves to protect your hands.
• Only use the special spring tension tool provided.
D.
For Jumper 251 count 24 holes from Point ZERO on the top bars and the
corresponding eyelets to move on to Point 24. Attach a spring to this point,
as shown in FIGURE 6. Now this is Point B.
E. For Jumper 251 count 12 holes from Point ZERO on the top bars and the
corresponding eyeletsto move on to Point12. Attach a spring to this point, as
shown in FIGURE 6. Now this is Point A.
!
CAUTION
ZERO
UltraFit
FIGURE 5