Ultrasport Ultra fit Jumper 251 Betriebsanleitung Seite 24

STEP 2 – Assembly of the support
Push all vertical leg extenders (#6) into the base (#5), as shown in FIGURE 2.
STEP 3 – Assembly of the top bars
Two people are required to assemble the trampoline in this step.
Lift one of the support components from Step 2 into the vertical position. Insert the top bar with the leg base into one end
of the support component. Insert the opposite end of the top bar with leg base into a second support group, as shown in
FIGURE 3.
Repeat this step until all support groups have been attached to the top bars with leg base.
Attach the top bar (#3/#4) into the gaps between the vertical leg extenders by inserting these into the gaps, as shown in
FIGURE 4.
FIGURE 2
FIGURE 3
FIGURE 4