Ordering Replacement Parts; Disposal And Recycling - EINHELL BT-LS 610 B Originalbetriebsanleitung

Anleitung_BT_LS_610_B_SPK1:_
Recommended hydraulic oil
We recommend that you use one of the following
makes of hydraulic oil for the hydraulic cylinder:
SHELL TELLUS T22
ARAL VITAM Gf22
SP ENGERGOL HCP22
MOBIL DTE11
or an alternative of the same quality
7.3.3 Cleaning/Replacing the oil filter
Undo the screw connection in the hydraulic line (Fig.
35a/Item A) and the four screws on the sealing plate
(Fig. 35a/Item B). Then carefully pry out the sealing
plate with a screwdriver, taking care not to damage
the sealing plate as you remove it. The oil filter can be
removed with the hydraulic line by turning it (Fig. 36).
Clean the oil filter with a cloth or replace it. Install it in
reverse order.
7.3.4 Motor circuit breaker switch (Fig. 1 / Item A)
If the motor is overloaded for a longer period the
motor circuit breaker switch will shut off the power
supply automatically.
This can be reset by pressing it in after waiting
approximately 1 minute. The wood splitter will then
be ready for use again.
7.3.5 Pressure control valve (Fig. 38 / Item A)
The pressure control valve was set correctly at the
factory and must never be adjusted.

7.4 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
20.04.2011 11:56 Uhr Seite 23
GB
23