Pkm WPT10-14A++ Bedienungsanleitung Seite 59

D
RUM
Remove the packaging foam inside the drum.
1. Open the door of the appliance.
2. Remove the adhesive strips from the inside of
the drum.
Do not use any aggressive or abrasive
detergents to remove residuals of the adhesive
strips.
3. Remove the packaging foam (X / 2 pcs.).
2.3 Levelling
1. Install the appliance on a flat and solid ground only.
2. Allow adequate distance to the floor to avoid
vibrations and noise.
3. If the appliance does not stand horizontally, adjust
the 4 feet
/ anticlockwise until the appliance is level.
Do not put any blankets or ropes or piles of items on the floor. They could
generate heat so that the appliance will not properly work.
2.4 Water drain hose
 During a drying process, usually the excess water runs into the integrated water
container of the appliance. However, you have the possibility to lead the excess
water directly to the outside (e.g. into a drain, a sink, a wash basin, etc.). To do
this, you must connect the water drain hose of the appliance to an external water
drain hose .
21
Depending on model.
20
Not included in the scope of delivery.
21
:
HOW TO REMOVE THE PACKAGING FOAM
by turning them
~
clockwise
~
59
20
Fig. similar