Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before initial operation, please check that all components are present and that
they are not visibly damaged.
2.2 Unpacking / site
1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
2. The appliance must not build in.
3. Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-protection.
4. Check that the appliance and the power cord are not damaged.
5. Do not install the appliance in a bathroom or a place where it may come in
contact with water or rain; otherwise, the insulation of the electrical system will
be damaged. Do not install the appliance in a room where explosive or flammable
gases are stored.
6. Protect the appliance from direct sunlight.
7. Install the appliance in a dry and well-ventilated place. The room temperature
must be higher than +
8. Install the appliance in a suitable position with an adequate distance from sources
of heat and cold.
9. Do not install the appliance on a carpet / fitted carpet.
10. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
11. Connect the appliance to the mains properly.
12. The nameplate is situated at the back of the appliance.
5 °C.
~
~
58
Werbung
