Victron energy Smart BMS 12-200 Bedienungsanleitung Seite 10

3.5. [en] Configuration
3.5.1. [en] Smart BMS settings
[en] The Smart BMS is configured via Bluetooth and the VictronConnect app. See the
installation details. The following steps describe the configuration process and options:
1. [en] Power up the Smart BMS according to the
2. [en] Open VictronConnect. The Smart BMS will appear on the Device list either under My devices or Other devices (the latter
when connecting for the first time).
3. [en] Tap on the Smart BMS. The pairing dialogue will start (default PIN code is 000000).
4. [en] Once connected, the Battery status page is displayed, showing the lithium battery voltage, the soft switch state, System+
status (on or off), Alternator/Starter voltage, System+ voltage and the alternator charge current percentage, followed by BMS
status messages. When connecting for the first time, a popup message appears asking you to set the fuse type in the
Settings menu to also be able to see the charge current (in percentage).
5. [en] Tap the cog wheel in the top right to open the Settings menu and set the following:
a. [en] Fuse type:
[en] Set the correct fuse type rating as explained in the
installed fuse.
b. [en] Battery Pre-alarm usage:
[en] In case of a lithium battery without pre-alarm feature, change the Battery Pre-alarm usage to 'Pre-alarm not
available', otherwise leave the default setting 'Use pre-alarm'.
c. [en] Pre-alarm:
[en] Choose between continuous and intermittent pre-alarm.
d. [en] Battery charge limit:
[en] Set the Battery charge limit (range: 13.0V..15.3V) to a value at which charging should be deactivated. Normally this
value should be 14.2V for a Victron Lithium Battery Smart. As soon as this value is reached, the battery charge is stopped
by deactivating the alternator/starter battery+ input. The input will turn on again when the battery voltage is 0.5V below the
battery charge limit for 10 (consecutive) seconds.
e. [en] Remote on/off function:
[en] This setting defines what is controlled by the remote on/off terminals. The default is that it only disables Alternator
and System+. Use the 'Switch everything off' option to make it a complete system on/off switch.
6. [en] The configuration of the Smart BMS is now complete and the status is displayed. Depending on the system status,
additional information is shown.
Seite 8
Smart BMS 12-200
Installation chapter [7].
Installation chapter [7]. Make sure it matches with the physically
VictronConnect manual for download and
Installation and configuration