ZENEC ZE-RVC60MT Montageanleitung Seite 2

MOUNTING INSTRUCTIONS
RCA plug with video signal
connects to moni-/naviceiver
Due to its compact size the ZE-RVC60MT rear view camera is suitable to be integrated either into the license plate mounting
frame or even the trunk grip, depending on car model or customer preferences. The connection cable of the camera can
often be routed alongside the license plate illumination wires.
After installation, the camera picture may be adjusted by untightening the lens holding ring counterclockwise. Now you can
turn the camera around its line of sight in order to finetune the image position. Instant success is guaranteed, if somebody
else is simultaneously checking the image position on the monitor. Once you are satisfied with the adjustments retighten the
lens holder by hand.
CAUTION:
Use the included connection cable exclusively. Altering or replacing it will void your warranty.
*
Following the latest trend in vehicle electronics, newer cars mainly use a pulse width modulated power feed for outer
hull lights, which is unsuitable for imaging/video electronics, as it causes considerable distortion.
Technical Specifications:
EN
Image device:
TV system:
Viewing angle:
Sensor resolution:
Resolution of video-out: 400 TV lines
Minimum illumination:
Video output:
White balance:
Power supply:
Current consumption:
IP protection rating:
Operating temperature: -20° to 60° C
Camera mounts to either the license
plate holder or to the plastic body of
the license plate illumination insert
6.4 mm/¼" CCIQ II
NTSC
155° diagonal, 120° horizontal, 90° vertical
648 x 488 pixels
0.6 lux
1 Vp-p, 75 ohms, composite
Auto
7-14 volts, 12 V standard
40 mA Max.
IP68
ZENEC by ACR AG Bohrturmweg 1 CH-5330 Bad Zurzach Switzerland
REAR VIEW CAMERA
Body rotates for alignment
(GND)
Shielded video coax cable
Technische Spezifikationen:
DE
Kamerasystem:
TV System:
Betrachtungswinkel:
Sensor Aufl ösung:
Aufl ösung Ausgangssignal: 400 TV Linien
Minimale Helligkeit:
Video Ausgang:
Weissabgleich:
Spannungsversorgung:
Stromverbrauch:
Schutzklasse:
Betriebstemperatur:
+12VDC
(not from reverse light feed,
connect elsewhere) *
Fuse 3 A
Power cable
6.4 mm/¼" CCIQ II
NTSC
155° diagonal, 120° horizontal, 90° vertikal
648 x 488 Pixel
0.6 Lux
1 Vp–p, 75 Ohm
Automatisch
7–14 Volt, 12 V Standard
40 mA Max.
IP68
-20° C ~ 60° C