Vector Control - Lenze 8200 motec Montageanleitung

Vector control

The following instructions apply to controllers equipped with a standard−I/O function
module and a three−phase AC motor which has been selected according to a power−based
assignment.
Switch−on sequence
1. Connect keypad
2. Ensure that controller inhibit is active after mains
connection
3. Switch on the mains
4. The keypad is in "Disp" mode after approx. 2 s and
indicates the output frequency (C0050)
5.
6. Go to the ALL menu
Change to the f mode to configure the basic
7.
settings for your drive
8. Adapt the terminal configuration to the wiring
(C0007)
Lenze setting: −0−, i. e.
E1: JOG1/3 fixed setpointselection
E2: JOG2/3
E3: DCB DC brake
E4: CW/CCW rotation
9. Set the minimum output frequency (C0010)
Lenze setting: 0.00 Hz
10. Set the maximum output frequency (C0011)
Lenze setting: 50.00 Hz
11. Set the acceleration time T
Lenze setting: 5.00 s
12. Set the deceleration time T
Lenze setting: 5.00 s
13. Activate the operating mode "vector control" (C0014
= 4)
Lenze setting: Linear V/f characteristic control
(C0014 = 2)
14. Adapt the voltage/current range for the analog
setpoint selection (C0034)
Lenze setting: −0−, (0 ... 5 V/0 ... 10 V/0 ... 20 mA)
15. Enter the motor data
A Rated motor speed (C0087)
Lenze setting: 1390 rpm
B Rated motor current (C0088)
Lenze setting: Depending on the controller
C Rated motor frequency (C0089)
Lenze setting: 50 Hz
D Rated motor voltage (C0090)
Lenze setting: Depending on the controller
E Motor cosj (C0091)
Lenze setting: Depending on the controller
EDK82MV222 DE/EN/FR 11.0
(C0012)
ir
(C0013)
if
l
Commissioning
Vector control
Comment
Terminal X3/28 = LOW
The USEr menu is active
Blinking on the display: 0050
Set the DIP switch on the standard I/O
to the same range (see Mounting
Instructions for the standard I/O)
See motor nameplate
Enter the value for the motor circuit
configuration (star/delta) selected!
Enter the value for the motor circuit
configuration (star/delta) selected!
7
115