Silvercrest SPWD 180 I1 Kurzanleitung Seite 10

SilverCrest SPWD 180 I1
Before you start
Activating the batteries
Replacing the batteries
Replace the batteries when they are empty. To replace the
lithium batteries CR2032, remove the cover of the battery
compartment (7) at the rear of the diagnostic scales by
inserting a finger into the recess of the battery compartment
(7). Then lift the battery compartment (7) cover upwards and
remove it.
To remove the batteries, push them down a bit (see the
direction of the arrow in the illustration). You can then remove
the batteries from the holder.
Then insert two new CR2032 lithium batteries. Always pay
attention to the polarity. This is indicated in the battery
compartment (7), and the + symbol on the CR2032 lithium
batteries must be visible, as shown in the adjoining illustration.
Next insert the battery compartment (7) cover back to its
original position. The diagnostic scales are now ready to use.
8 - English
Remove the strip from the battery compartment (7) on the
bottom of the diagnostic scales. The diagnostic scales are
now ready to use.