Parts Name Of Remote Controller - Toshiba MMU-AP0091H Betriebsanleitung

PARTS NAME OF REMOTE CONTROLLER

Display section
In the display example, all indicators are displayed for the explanation.
In reality only, the selected contents are indicated.
• When turning on the leak breaker at the first time, [SET DATA]
flashes on the display part of the remote controller. While this
display is flashing, the model is being automatically confirmed.
Accordingly, wait for a while after [SET DATA] display has disap-
peared, and then use the remote controller.
2
3
4
5
6
7
15
1
SET DATA display
Displayed during setup of the timer.
2
Operation mode select display
The selected operation mode is displayed.
3
CHECK display
Displayed while the protective device works or a
trouble occurs.
4
Timer time display
Time of the timer is displayed.
(When a trouble occurs, the check code is dis-
played.)
5
Timer SETIN setup display
When pushing the Timer SETIN button, the
display of the timer is selected in order of [OFF]
→ [OFF] repeat OFF timer → [ON]
→ No display.
6
Filter display
If "FILTER " is displayed, clean the air filter.
7
TEST run display
Displayed during a test run.
8
Flap position display
(for 4-Way Air Discharge Cassette Type and
Under Ceiling Type model only)
Displays flap position.
9
SWING display
Displayed during up/down movement of the flap.
1
8
SET DATA
UNIT No.
SETTING
TEST
R.C. No.
10
11
12
13
14
15
6
SET DATA
UNIT No.
SETTING TEST R.C. No.
UNIT
SET CL
CODE No.
10
12
14
Set up temperature display
The selected set up temp. is displayed.
Remote controller sensor display
Displayed while the sensor of the remote
controller is used.
PRE-HEAT display
(for Heat-pump model only)
Displayed when the heating operation
starts or defrost operation is carried out.
While this indication is displayed, the
indoor fan stops or the mode enters in
LOW.
Operation ready display
Displayed when cooling operation is
unavailable because heating operation is
performed.
No function display
Displayed if there is no function even if
the button is pushed.
Air volume select display
The selected air volume mode is dis-
played.
(AUTO)
(HIGH)
(MED.)
(LOW)
In the Concealed Duct High Static Pres-
sure type models, [HIGH] only is
displayed for the air speed.
CODE No.
Display
section
Operation
section
9
11
13