Toshiba MMU-AP0091H Betriebsanleitung Seite 15

Under Ceiling Type
• While the air conditioner stops, the horizontal flap (Up/Down air direction adjustment plate)
automatically directs upward.
• While the air conditioner is in ready status for heating, the horizontal flap (Up/Down air direc-
tion adjustment plate) directs upward. The swinging operation starts after heating ready status
has been cleared, but "SWING
ready to heating.
How to set up the air direction
Push button during operation.
In Heating operation
Set the horizontal flap (Up/Down
air direction adjustment plate)
downward. If directing it upward,
the hot air may not come to the
foot come to the foot.
How to start swinging
2
Push button.
Set direction of the horizontal flap (Up/Down air
direction adjustment plate) to the lowest posi-
tion and then push
• [SWING ] is displayed and the air direction
automatically changes upward/downward.
In case when one remote controller controls the
multiple indoor units, each indoor unit can be
selected and its air direction can be set up.
How to stop swinging
3
Push button again during swinging of
the horizontal flap.
• The horizontal flap can be stopped at the desired
position. After then the air direction can be again
set up from the uppermost position by pushing
button.
* While the horizontal flap is set downward in
cooling/drying operation, it does not stop.
If stopping the horizontal flap which directs
downward during swinging, it stops after moving
to the 3rd position from the top position.
4
UNIT
• To set up the air direction individually, push
button to display each indoor unit No. in
UNIT
a group control. Then set up the air direction to a
displayed indoor unit.
• If there is no display, all the indoor units can be
operated collectively.
• Every pushing
exchanges as shown in the figure.
No display Unit No. 1-1
Unit No. 1-4
" is displayed on the remote controller even if the status is
Initial setup
button again.
button, the display
UNIT
Unit No. 1-2
Unit No. 1-3
1
Every pushing the button, the air direction changes.
In Cooling / Dry operation
Set the horizontal flap (Up/Down
air direction adjustment plate)
upward. If directing it downward,
the dew may fall on near the air
air outlet port or it drips.
1, 2, 3
In FAN operation
Display when stopping the swing
12
UNIT
SET CL
In all modes
Initial setup
Fan/Heat
operation
Initial setup
4
Series of
operation
Cool/Dry
operation