Toshiba MMU-AP0091H Betriebsanleitung Seite 17

Floor Standing Cabinet Type
[In Cooling operation]
In cooling operation, use the air outlet flap with horizontal set
point so that the cold air diffuses in whole room.
[In Heating operation (For Heat-pump model only)]
In heating operation, use the air outlet flap with downward set
point so that the hot air blows at the foot.
How to change the air outlet port
Change the air outlet port in the following procedure.
1
Take off two fixing screws of the air outlet port.
(The fixing screws are reused.)
2
Insert the hand into the air outlet port and push up it
a little, and then remove the air outlet port from the
claw hook at rear side.
3
Lift up the air outlet port upward and remove it.
4
Reverse the air outlet port and attach it to the main
unit.
Pay attention so that four claw hooks (two at rear and
lower sides each) are hooked at mounting position.
5
Be sure to tighten the air outlet port with the re-
moved fixing screws so that the air outlet port does
not come off.
14