Preparing For The Installation - Megasat WSTA-DP250PMS Bedienungsanleitung

Preparing for the installation

Preparing for the instal Preparing for the instal Preparing for the instal
Install Tools and Materials
WSTA-DP250PMS antenna system is designed for simple installation and setup. However,
the following list of equipment or items should be available during installation of WSTA-
DP250PMS antenna.
■ Electric drill and drill bits
■ Socket wrench
■ Silicon sealant
■ Fastener suitable for specific application
1. Verification of the Vehicle's Power Supply.
■ Confirm that the vehicle's power supply is 12VDC~24VDC or
Power supply with 230VAC to 12VDC 5A.
2. Verification of the Satellite Receiver and IDU's attachment and the electricity supply
■ Attach Satellite Receiver and IDU in the interior of the vehicle or the trunk.
■ Connect the power of Satellite Receiver and IDU.
■ Once the power of Satellite Receiver and IDU is verified, it confirms that both
Satellite Receiver and IDU are working normally.
3. Procedure of the satellite's attachment and installation.
■ Attach the satellite on the flat surface area of the vehicle's roof.
■ Connect each end of the Coaxial antenna cable to the satellite's terminal and the IDU.
■ Connect the IDU and the Satellite Receiver box together through the coaxial cable.
■ Make sure that the satellite is working normally, once the power is supplied.
Warning : Things to consider when installing the antenna.
antenna.
surface.
properly.
lation lation lation
■ Turn off the power when attaching or detaching the
■ Make sure that the attached satellite is fixed on the flat
■ When attaching, ensure that all the products are adhered
■ Ensure that all the cables are connected properly.
32