Gain Controls - Omnitronic MX-420 Bedienungsanleitung

15
Headphones input
Input (optionally 3.5 mm jack or 6.3 mm jack) for
connecting stereo headphones (impedance ≥8 Ω).
16
Selector switch CUE MODE
For selecting the monitoring mode for the headphones
output:
• SPLIT (button pressed, red LED lights): The prefader
level (mono) is on one side and the output signal (mono)
is on the other side of the headphones.
• MIX (button released, blue LED lights): A mixed signal
of prefader level and master signal is on both sides of
the headphones.
17 Control BOOTH LEVEL
Level control for the output BOOTH.
18 Control MASTER 2
Level control for the master channel 2.
19
Selector switch MODE
Stereo/mono switch for both master channels.
• MONO (button pressed, red LED lights): master
channels are switched to mono
• STEREO (button released, blue LED lights): master
channels are switched to stereo
20 Selector switch LED METER
Button for switching the LED level meter between the two
master channels.
• M2 (button pressed, red LED lights): level indication of
master channel 2
• M1 (button released, blue LED lights): level indication of
master channel 1
21 Selector switch DJ MIC TO REC
Switches the DJ microphone channel at the outputs
REC(CORD) on and off.
• + (button pressed, red LED lights): recordings with
microphone signal
• - (button released, blue LED lights): recordings without
microphone signal
22
Output REC(CORD)
Stereo output (RCA) for connecting an additional
recording unit. The recording level is independent of the
position of the master fader and the output controls
MASTER 2 and BOOTH LEVEL.
23 Inputs LINE 10
Inputs (optionally 3.5 mm jack or stereo RCA) for
connecting an additonal unit with line level output (e.g.
CD player).
24 Output level LED meter L/R
10-digit LED meter; depending on the position of the
selector switch LED METER it indicates the level of
master channel 1 or of master channel 2 within the range
of -24 dB to +9 dB.
25
Tone controls
3-band equalizer for the channels 1-4: TREBLE,
MIDDLE, BASS.
26 Input selectors
For selecting the input source for the channels 1-4.
27

Gain controls

Adjust the input amplification for the channels 1-4.
20/26 00041734.DOC, Version 2.0