Announcements Via The Dj Microphone; Prefader Listening To The Channels; Cleaning And Maintenance - Omnitronic MX-420 Bedienungsanleitung

5 If crossfading is not required, the connected audio sources can be switched directly to the master signal:
Set the corresponding assignment selectors to position "M" and adjust the desired volume ratio of the
audio sources with the channel faders.

6.4 Announcements via the DJ microphone

1 To switch on the DJ microphone at the jack DJ MIC press the button ON AIR (control LED lights red).
2 Adjust the volume of the microphone announcement with the control LEVEL.
3 Adjust the desired sound with the 3-band equalizer. By adjusting the tone controls, the high frequencies
(control TREBLE), the middle frequencies (control MIDDLE) and the low frequencies (control BASS) can
be boosted or attenuated (± 12 dB).
4 To improve the audibility of an announcement during the current music program, press the button
TALKOVER (control LED lights blue) to activate the talkover function. Then during a microphone
announcement, the levels of channels 1-4 are automatically attenuated by 15 dB.
5 To switch off the DJ microphone press the button ON AIR again (control LED off).

6.5 Prefader listening to the channels

The cue function allows monitoring each of the channels 1-4 via headphones even if the corresponding
channel is faded out. Thus, it is possible, e. g. to time the moment for fading in an audio source. Alternatively
it is also possible to monitor the current music program ahead of the master fader or the output controls
MASTER 2 and BOOTH LEVEL.
1 For prefader listening to a channel, press the corresponding switch CUE (control indicator lights) and set
the fader CUE MIXING to the left position "CUE". To monitor the current music program ahead of the
master fader and the output controls MASTER 2 and BOOTH LEVEL, set the fader CUE MIXING to the
right position "MASTER".
2 Select the monitoring mode with the selector switch CUE MODE:
• SPLIT (button pressed, red LED lights): The prefader level (mono) is on one side and the output signal
(mono) is on the other side of the headphones.
• MIX (button released, blue LED lights): A mixed signal of prefader level and master signal is on both
sides of the headphones.
3 Adjust the desired headphones volume with the control CUE LEVEL.

7. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
25/26 00041734.DOC, Version 2.0