Dmx Mode - EuroLite ZEITGEIST SPOT 210 Bedienungsanleitung

DMX Mode

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the Zeitgeist Spot 210 will respond to the controller.
Controlling:
After having addressed the Zeitgeist Spot 210, you may now start operating it via your lighting controller.
Every DMX-channel has a different occupation with different features.
If you set, for example, the address in the 25 channel mode to channel 26, the Zeitgeist Spot 210 will use
the channels 26 to 50 for control.
Please, be sure that you don't have any overlapping channels in order to control each Zeitgeist Spot 210
correctly and independently from any other fixture on the DMX-chain. If several Zeitgeist Spot 210 are
addressed similarly, they will work synchronically.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the display will flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Addressing
DMX MODE
ADDR:001
Set the desired address via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to select a DMX Channel Mode.
DMX Channel Selection : Choosing a DMX Channel Mode
DMX MODE
CH: 03/04/05/06/21/22/25
Set the desired mode via the UP or DOWN buttons.
Press the ENTER button again to confirm and to exit the DMX MODE.
Please see the following DMX protocol graphic for the respective channel values.
Press the MODE button until the display shows DMX MODE.
Press the ENTER button and the display shows: 001.
After having set the desired address and pressed ENTER, you can now
choose a DMX Channel Mode. (3 CH, 4 CH, 5 CH, 6 CH, 21 CH, 22 CH
or 25 CH).
33/40 00080219.DOC, Version 1.0