Parameter Setting 12 V - 20 V - Sartorius X6 System Weighing Controller Zusatzinformation

X6 System Weighing Controller
Parameter setting 12 V – 20 V
3.2
In [Setup]-[Weighingpoints]-[WP X:Internal ADC]-[Calib]-[Param] the load cell supply voltage has to be
selected:
WP X: Internal ADC
- Assign
- Calib
- New
- Modify
- Param
- Analog filter
- Digital filter
- Multirange mode
- Test mode
- W & M
- * Fcut
- * Measuretime
- Standstill time
- Zerotrack time
- Tare timeout
- Standstill range
- Zeroset range
- Zerotrack range
- Zerotrack step
- Supply
- Overload
- Don't print below
- * Multirange limit 1
- * Multirange limit 2
- Check
- View
If the load cell supply voltage jumpers are changed from 12 V (default) to 20 V, the voltage in the
menu [Param] has to be set to 20 V as well.
Sartorius
<12 Volt>, 20 Volt
Select with 20 Volt (only for PR 5710),
default value is 12 Volt
PR 5710 Additional Information
15