Replacing The Lamp; Closing The Door; Installation; Rear Spacers - Electrolux SG215N Benutzerinformation

14 www.electrolux.com
Problem
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

7.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

8. INSTALLATION

WARNING!
Refer to Safety chapters.
8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
SN
N
ST
T
Possible cause
The temperature regula‐
tor is not set correctly.
Food products placed in
the appliance were too
warm.
The door has been
opened often.
The FROSTMATIC func‐
tion is switched on.
There is no cold air circu‐
lation in the appliance.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Solution
Set a higher/lower tempera‐
ture.
Allow food products to cool
to room temperature before
storing.
Open the door only if neces‐
sary.
Refer to "FROSTMATIC
function".
Make sure that there is cold
air circulation in the appli‐
ance.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.

7.3 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only
be guaranteed within the
specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer
service or to the nearest
Service Centre

8.2 Rear spacers

Install the spacers, provided within the
accessory bag, on the brackets of the
condenser (black grill) at the back of the
appliance, as shown in the figure.