Electrolux SG215N Benutzerinformation Seite 13

Problem
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the FROSTMAT‐
IC, or after changing the
temperature.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
Door is misaligned or inter‐
feres with ventilation grill.
Possible cause
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The FROSTMATIC func‐
tion is switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
This is normal, no error
has occurred.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FROSTMATIC func‐
tion is switched on.
The appliance is in dem‐
onstration mode.
The appliance is not lev‐
elled.
ENGLISH
Solution
Close and open the door.
Contact the nearest Author‐
ized Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FROSTMATIC
function".
Refer to "Closing the door".
The compressor starts after
a period of time.
Attach the melting water out‐
let to the evaporative tray.
Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Refer to "Levelling".
13