To Start The Product; To Remove Air From The System Of The Product; To Stop The Product; To Operate The Product - Meec tools 026572 Bedienungsanleitung

4
Open the valve in the tap. Make sure that there is no
leakage.

4.3 To start the product

1
Put the product in an upright position on a level and
stable surface. (Figure 5)
2
Connect the garden hose to a water source. Refer to
"4.2 To connect the product to a water source" on
page 33.
3
Make sure that the power switch is in the "OFF/0"
position. (Figure 9)
4
Connect the power plug to an earthed power outlet.
5
Turn the power switch to the "ON/1" position to start
the product.
4.4 To remove air from the system of
the product
Remove air from the system of the product before you
operate the product.
1
Start the product. Refer "4.3 To start the product" on
page 34
2
Open the water supply.
3
Unlock the trigger of the spray gun.
4
Push the trigger of the spray gun. The product starts.
5
Let the product operate until the water exits from the
spray gun handle without bubbles. Do not let the
product operate for more than 2 minutes.
6
Release the trigger of the spray gun.
7
Lock the trigger of the spray gun.

4.5 To stop the product

1
Release the trigger of the spray gun and lock the
trigger lock.
2
Put the spray gun in the spray gun holder.
3
If the break is longer than 5 minutes, turn the power
switch to the "OFF/0" position.
34

4.6 To operate the product

Warning! Use safety glasses and applicable personal
safety equipment.
Warning! Do not point the spray gun in a direction
where the water jet can cause injury or damage.
Warning! Do not go away from the product when it is
in operation.
Warning! Always engage the lock of the trigger before
you take a pause from operation.
Warning! Always turn the power switch to the "OFF/0"
position if you are away from the product for more than 5
minutes.
1
Start the product. Refer to "4.3 To start the product"
on page 34.
2
Open the water supply.
3
Point the spray wand at the surface to be cleaned.
4
Unlock the trigger of the spray gun.
5
Hold the spray gun tightly with both hands. Push and
hold the trigger of the spray gun and move the spray
wand over the surface until the surface is clean.
6
Release the trigger of the spray gun to stop the
operation of the product. High pressure remains in
the system.
Warning! Beware of kickback when the trigger is
pushed.

4.7 To do after operation

Warning! Hot water can flow out when you dis-
connect the water hose or the high-pressure hose after
operation.
Caution! The product must be disconnected from the
water supply after operation.
1
Stop the product. Refer to "4.8 To stop the product"
on page 34
2
Disconnect the water hose from the water inlet on
the product.