Cleaning The Product; Charging The Battery - Meec tools 016364 Bedienungsanleitung

4. Remove the spray head (9).
5. Store the spray head upright with the
connection down.
6. Empty the suction hose and filter basket
(10) of water.
7. The product and accessories can
freeze and be damaged if they are not
completely empty.
8. Store the product and accessories in a
frost-free place.

Cleaning the product

WARNING!
Do not clean the product with running
water – risk of electric shock and/or material
damage.
NOTE:
Do not use detergents or solvents.
• Keep the ventilation openings (1) on the
product clean.
• Clean product with a soft brush or damp
cloth.
• If the nozzles (8) on the spray head (9)
are contaminated or blocked they can be
cleaned with a needle.
• Rinse the nozzles with water to remove
impurities.
USE
BATTERY
Battery and charger sold separately in Jula's
department stores and at www.jula.com.
WARNING!
Make sure that the power switch on the tool
is not pressed in when inserting or replacing
the battery.
NOTE:
Connect the battery with moderate pressure
– do not force. An incorrectly connected
battery can damage the battery terminals or
the battery socket on the tool.
CHARGING LEVEL
To check the battery charge level, press the
"Press" button to see 1-4 red LEDs, where 1
indicates low battery level and 4 high level.
FIG. 5

CHARGING THE BATTERY

NOTE:
• The battery must be charged before it
can be used with a power tool.
• After charging for the first time, use the
tool until the battery is completely flat.
Repeat this charging and discharging
cycle 4 to 5 times.
• If the LEDs on the charger do not go on
when charging:
– check that the mains adapter for
the charger is properly plugged into
the power point and that the
charger is switched on.
– check that the battery is correctly
inserted in the charger.
1. Place the battery charger on a level and
stable surface. Plug the charger into a
230 V power point.
2. Connect the battery to the charger so
that it clicks in place. The red LED on the
charger goes on when correct contact is
made.
FIG. 6
3. When the battery is fully charged, after
about one hour, the red LED goes off and
only the green LED stays on.
4. Unplug the charger from the power point
and remove the battery from the charger.
EN
31