Werbung
Verfügbare Sprachen
Verfügbare Sprachen
11
Troubleshooting
Problem
The product does not start.
The pressure in the system is not
constant.
The product stops.
The product pulsates.
38
Cause
The power plug is not connected.
There is no power in the power outlet.
The fuse has tripped.
The extension cord is defective.
There is air in the system.
The valves are blocked, worn or cannot
move.
The pump seals are worn.
The power outlet has incorrect voltage.
The product is overheated and the
overheat protection has engaged.
The nozzle in the spray head is partially
blocked.
There is air in the water hose.
The water supply is unsatisfactory.
The nozzle in the spray head is partially
blocked.
The filter in the water inlet is partially
blocked.
The water hose is bent or pinched.
Solution
Connect the power plug to a power
outlet.
Use a different power outlet.
Stop other products that are
connected to the same circuit and
replace the fuse.
Replace the extension cord or
.
operate the product without the
extension cord.
Make sure that all hoses and
connections are airtight.
Speak to an authorized service
center.
Speak to an authorized service
center.
Make sure that the voltage in the
power outlet corresponds to the
rated voltage on the type plate on
the product.
Wait at least 5 minutes until the
product has become cool before
you operate the product.
Clean the nozzle in the spray head.
Refer to "6.3 To clean the spray head
nozzle" on page 35.
Remove the air from the system.
Refer to "4.4 To remove air from the
system of the product" on page
34.
Make sure that the water inlet
pressure is sufficient.
Clean the nozzle in the spray head.
Refer to "6.3 To clean the spray head
nozzle" on page 35
Clean the filter. Refer to "6.2 To clean
the filter" on page 35.
Make sure that no section of the
water hose is bent or pinched.
Werbung
