Meec tools 026572 Bedienungsanleitung Seite 35

3
Turn the power switch to the "OFF/0" position.
4
Disconnect the power plug from the power source
and roll up the power cord on the power cord holder.
5
Push the trigger of the spray gun to release pressure
from the system.
6
Release the trigger of the spray gun
7
Lock the trigger of the spray gun.
5 Transport
5.1 To transport the product by hand
Warning! Be aware of the weight of the product. Be
careful when you move the product.
1
Stop the product. Refer to "4.5 To stop the product"
on page 34
2
Disconnect the power plug from the power source
and roll up the power cord on the power cord holder.
3
Disconnect the water hose from the water inlet on
the product.
4
Carry the product by the transport handle.
5.2 To transport the product with a
vehicle
1
Stop the product. Refer to "4.8 To stop the product"
on page 34
2
Disconnect the power plug from the power source
and roll up the power cord on the power cord holder.
3
Disconnect the water hose from the water inlet on
the product.
4
Make sure that product can not move around in the
vehicle when you transport the product.
Warning! Vibrations and shocks can cause damage
to the product. Use applicable transport protection when
you transport the product with a vehicle.
6 Maintenance
6.1 To clean the base unit
Warning! Always stop the product, disconnect the
power plug, and release the pressure in the system before
you clean or do maintenance on the product.
Warning! Do not immerse the product in water or
other liquid. Risk of electrical shock.
● Clean the base unit with a damp cloth.
6.2 To clean the filter
Warning! Always stop the product, disconnect the
power plug, and release the pressure in the system before
you clean or do maintenance on the product.
1
Stop the product. Refer to "4.8 To stop the product"
on page 34
2
Disconnect the water hose from the water inlet on
the product.
3
Carefully pull out the filter in the water inlet. Use
flat-nose pliers.
4
Rinse the filter in clean hot water.
5
Install the filter in the water inlet.
6.3 To clean the spray head nozzle
Warning! Always stop the product, disconnect the
power plug, and release the pressure in the system before
you clean or do maintenance on the product.
1
Stop the product. Refer to "4.5 To stop the product"
on page 34.
2
Remove the spray head from the spray gun.
3
Use the nozzle cleaning tool (included with the
product) to remove unwanted materials from the
nozzle on the spray head.
35