Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Master/slave operation
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled with the
master unit without the need for a DMX controller. The devices must be set to the corresponding operating modes.
1
Configure all slave units before connecting the master unit. Press the MODE button so many times until
MASTER OFF is indicated on the display. Confirm with the ENTER button. Then via the UP/DOWN buttons set
each Slave device to MASTER: OFF and confirm with ENTER.
2
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the DMX
output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been connected
in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller to the DMX input
of the master unit.
3
Now press the MODE button so many times until MASTER OFF is indicated on the display. Confirm with the
ENTER button. Then via the UP/DOWN buttons set the Master device to MASTER: ON and confirm with
ENTER.
4
Select the desired show mode at the master unit (See Menu Structure). The interconnected devices will now
operate synchronously.
DMX operation
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 5 control channels. However, it
can also be switched to a mode with 4 channels if different functions are required. To be able to operate the device
with a DMX controller, the DMX starting address must be set. The starting address depends upon which DMX
controller is being used. Please refer to the controller's documentation.
1
Press the MODE button so many times until DMX Adr 001 is indicated on the display. Confirm with the ENTER
button. Via the UP/DOWN buttons you can set the desired starting address. Confirm with the ENTER button.
2
In order to set the desired DMX channel mode, press the MODE button until Channel: 04 is indicated on the
display and press ENTER. Use the buttons UP/DOWN to select the desired DMX channel mode (4CH / 5 CH).
Confirm with the ENTER button.
3
The DMX signal indicator LED on the device rear will flash when DMX signals are being received (see
Description of the Device).
Note: Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX chain. If several devices are defined to the same address,
they will work synchronously.
24/28
00147009.DOCX, Version 1.0
Werbung
