Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C Putting into Operation
1.
Ensure that the boiler is connected up and switched on.
2.
Start up the unit by pressing the ON button. The display flashes until
the correct temperature is set (continuous flashing without hot
water).
If an error message appears (Err 1, 2, ...) please refer to the
Troubleshooting section.
3.
Press OFF to stop the flow of water.
4.
Adjustments
4.1
Time
Pressing the Time button calls up the time of day. This can be done
in the OFF mode and in the ON mode, where the temperature
display disappears briefly.
To set the time the TIME button must be pressed for approx. 4
seconds. There is a beep and the time flashes. Now the hours can
be set with the TEMP buttons and the minutes can be set with the
VOL buttons. The Up arrow increases the figure and the Down
arrow lowers the figure.
By pressing the TIME button again the time you have set is saved.
4.2
Switching from the 24 h mode to the 12 h mode
If necessary the unit can be switched to the 12 h mode. To do so,
press the buttons
simultaneously with the unit closed. The switchover is
acknowledged by a beep. A switch back to the 24 h mode is
performed in the same way.
4.3
Continuous time display
If you wish to display the time continuously when the unit is closed,
press the buttons
simultaneously with the unit closed.
In this mode the time display remains when the unit is switched off
until a button is pressed. It can be switched back again in the
same way.
ECO
AUTO
Page 17
Werbung
