Werbung
Verfügbare Sprachen
Verfügbare Sprachen
B Installation Instructions
7
Now slide the valve body onto the spherical heads of the off-centre
connection pieces (take care not to damage the O-rings on the
off-centre connection pieces) and hand-tighten it to the flange
with the screws (approx. 2 Nm).
8
Postion the electronics box as shown in the illustration. Attach the
motor connection cable, the left-hand cable (1) and the right-hand
cable (2) to the left-hand and right-hand motor connectors (jack
(5) upwards).
Insert the connector on the sensor cable (3) into the socket at the
centre of the electronics box.
Hold the electronics box in front of the tiled wall and hand-fasten it
to the wall with two screws (4).
Important: If the joints between the tiles are deeper than normal, fill
them up around the sponge rubber seal of the electronics box, with
silicone for example.
HOT
2
1
3
4
COLD
5
4
Page 14
Werbung
