Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A Operating Instructions
3.
Operation with a hydraulically controlled flow heater
In conjunction with a hydraulically controlled flow heater the flow
cannot be reduced on account of the heating power provided by
the flow heater. For this reason always enter full jet intensity in all
programmes.
Alternating H/C shower may only be used under certain
circumstances.
Note: This limitation does not apply to electronically controlled flow
heaters or gas flow heaters with modulated heating output.
Only UK:
In connection with the Twin pump the flowrate must only be
reduced to a point where a secure switch-on of the pump is still
ensured.
4.
Additional information
4.1
Under certain conditions the electronic control system performs a
self-calibration process. For temperature adjustment the motor
runs for approx. 3 seconds. During that time the unit cannot be
started up.
4.2
If for unforeseeable reasons (e.g. if the building is hit by lightning or
if the batteries are short-circuited) the unit fails to close, the flow of
water can be stopped with a emergency shut off screw.
For this purpose the unit is supplied with a key, the use of which is
described below.
Surface-
mountes
5.
Error codes
Error codes (Err. 1, 2, ...) on the display are explained in more detail
in the section Putting into Operation.
To close off
Page 11
Werbung
