Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOTICE
When using
material pressure vessels
X
also observe the operating manual for the
pressure vessel!
L
• Protect yourself and other persons, ani-
mals, property, and the environment by
taking the necessary protective measures
and being trained in use of the devices to
prevent harm to your health, property
damage,
financial
harm or risk of accident.
• Be calm and focused and ensure proper
operation.
• Repairs may be carried out only by
Schneider Druckluft GmbH or its approved
service partners.
• Prohibited: manipulation, inappropriate
use, temporary repairs, use of other ener-
gy sources, removal or use of damaged
safety equipment, operating a leaking or
malfunctioning system, use of non-original
spare parts, exceeding the permitted
working pressure specified (max. + 10%),
working without protective equipment,
transporting / maintaining / repairing or
leaving a pressurised machine unattended,
using other / unsuitable lubricants, smok-
ing, naked flames, removing stickers.
• Prohibited: Using explosive or flammable
cleaning agents; disposing of leftover ma-
terials / cleaning agents incorrectly.
• Prohibited: Use in medical / food indus-
try; incorrect processing equipment; spark
formation.
2.4
Commissioning
Before start-up:
1. Observe technical data, figures, item
numbers, intended use and safety in-
structions
(see Instruction manual, Part 1, Chap-
ter: "Technical data" and the "Intended
use" chapter).
2. Carry out a visual inspection.
3. Do not use below 5° C.
loss,
environmental
4. Use corresponding nozzle set (item 10-
13), (Figure 3c).
5. Observe manufacturer's instructions for
paint processing.
6. Add material to paint vessel (refer to
part 1 of the operating manual).
Compressed air connection:
1. Connect a filter pressure reducer up-
stream of the filter.
2. Press the quick-action coupling of the air
hose onto the plug nipple (item 01)
(Figure 1a).
3. If necessary, use a microfilter and acti-
vated charcoal filter.
Operation:
1. Adjust the working pressure on the filter
pressure reducer.
2. Press the trigger lever (item 02).
3. When using material pressure vessels,
observe the material / air pressure set-
ting and Part 1 of the Instruction manual
(Technical data).
4. Maintain the same distance to the
sprayed object, approx. 15-25 cm.
5. Do not move from side to side, spray
parallel to the sprayed object.
Settings:
1. Round spray setting (item 04):
turn towards the right for smaller surfac-
es, corners, edges.
2. Wide spray setting (item 04): setting for
horizontal or vertical distribution.
Turn towards the left for larger surfaces.
L For paint spray guns with slotted nozzle,
this adjustment is unnecessary.
3. The paint quantity is adjusted at the
paint
quantity
present, item 03).
4. Air
quantity
item 08): turn towards the right for less
air (Figure 2a).
FSP
regulating
valve
regulation
(If
present,
GB
(if
II/ 9
Werbung
