GreenWorks GD24X2LTK2x Benutzerhandbuch Seite 7

3.4 ATTACH THE AUXILIARY
HANDLE
Figure 4.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the auxiliary handle with the knob.
3.5 INSTALL THE BATTERY PACKS
Figure 5.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery packs.
• Use only 24V battery packs. Do not use dual-voltage
24/48V battery packs.
• Both battery packs should be installed in the
compartments in order to start the machine.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
4. Do the same operation with the other battery pack.
Optimize the power and performance of your new
2x24V machine by running with both battery packs
charged to 100%. If each battery has a different charge
state, the run-time of the machine is subject to the lowest
powered battery (For example: one battery is charged
100%, and the other is charged 50%, the unit will only
run until the 50% battery is depleted).
3.6 REMOVE THE BATTERY PACK
Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
IMPORTANT
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
WARNING
Be careful when you operate the machine.
NOTE
English
4.1 START THE MACHINE
Figure 6.
1. Push the lock-out button and pull the trigger.
2. Push the speed switch to the desired operating speed.
Push the speed switch to position 1 for low speed or
position 2 for high speed.
4.2 STOP THE MACHINE
Figure 6.
1. Release the trigger to stop the machine.
4.3 OPERATION TIPS
Figure 7.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Do these tips when you use the machine
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with the two hands on the machine
while you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• Remove the battery pack.
• Remove the grass.
4.4 CUTTING TIPS
Figure 8.
• Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
• Move the machine from right to left to prevent thrown
debris toward the operator.
• Do not cut in the dangerous area.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
4.5 ADJUST THE LENGTH OF THE
CUTTING LINE
Figure 9.
While you operate the machine, the cutting line gets worn and
shorter. You can adjust the length of the cutting line.
1. Hit the trimmer head against the ground while you
operate the machine.
5
WARNING
WARNING
EN