Attach The Guard; Attach The Auxiliary Handle; Install The Battery Pack; Remove The Battery Pack - GreenWorks 2107107 Bedienungshandbuch

3.3

ATTACH THE GUARD

Figure 3.
WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
3.4 ATTACH THE AUXILIARY
HANDLE
Figure 4.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Put the bolt through the holes.
5. Tighten the auxiliary handle with the knob.
3.5

INSTALL THE BATTERY PACK

Figure 5.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.6

REMOVE THE BATTERY PACK

Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4

OPERATION

IMPORTANT
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
English
Be careful when you operate the machine.
4.1

START THE MACHINE

Figure 6.
1. Push the on/off button.
2. Push the lock-out button and pull the trigger.
3. Push the speed button to adjust the speed according to the
grass condition.
4.2

STOP THE MACHINE

Figure 6.
1. Release the trigger to stop the machine.
4.3 ADJUST THE LENGTH OF THE
CUTTING LINE
Figure 6.
The machine has an auto-feed head. It will damage the
machine if you hit the head to try to advance the line.
If the cutting line does not automatically advance, it can be
tangled or empty.
1. When the machine is on, release the trigger.
2. Wait two seconds, push the trigger again.
The line will extend approximately 0.4 in. with each stop
and start of the switch trigger until the line reaches the cut-
off blade and the cut-off blade cuts the excess length.
4.4 ADJUST THE LENGTH OF THE
SHAFT
Figure 7.
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Push the lock button and move the lower shaft to the
desired position.
3. Release the lock button.
4.5

CHANGE TO THE EDGING MODE

Figure 8 - 9.
5
WARNING
NOTE
NOTE
NOTE
NOTE
EN