Sharp GF-5757H Bedienungsanleitung Seite 18

Erasing Recorded Tapes
Re-recording a tape will automatically erase the
previously recorded material.
Follow the instructions at right to erase a tape
without re-recording.
hy 3s Spacing
ae
O—
°o
EXT MIC
In order for the APSS to operate correctly, there
must be a space of at least 4-second duration
between each item on the tape. In order to edit
space (non-signal space) on tapes, follow the
instructions below.
"hb © ND =
Protection Against Cassette Tape Erasure
Depress the PAUSE If key during recording at
a point suitable for selection editing.
Slide the FUNCTION selector to the) /TAPE
position.
Connect the erasing plug {not supplied) to the
EXT MIC jack.
Depress the PAUSE II key to release it.
After sufficient editing time (about 5 seconds)
has elapsed, depress the PAUSE J] key.
'tte tape with side "A" (1)
U,,-ermost.
Side "'B" (2) protection tab
—5
1
2
3 Connect the erasing plug (not supplied) to the
4
Load a cassette-to be erased into the cassette
compartment.
Slide the FUNCTION selector to the ® /TAPE
position.
EXT MIC jack. i
Depress the RECORD ® key. This will auto-
matically engage the PLAY » key and begin
erasing the tape.
6 Remove the erasing plug from its jack.
7 in order to record from the built-in radio, slide
the FUNCTION selector to the ON/RADIO i
position. ;
8 Depress the PAUSE II key to release it and i
begin recording of the next selection. :
9 Perform steps 1—8 to edit spaces between selec-
tions so that the tape may be used for future
APSS operation.
Ali cassette tapes are provided with the tabs which,
when in place, allow the tape erasure. If the tab (A
or B/1 or 2) is removed, the tape on the side in
which tab was removed cannot be erased.
{The RECORD @ key can not be depressed.)
The tape can be re-recorded or erased by covering
the tab holes with plastic tape.