Eufab James Handbuch Seite 13

2 X Plastic Connecting Piece
Wheel Stopper from Centre Outwards
The rails are fixed to the carrier table with the M6 X 75 carriage bolts, which are located under the
rails. Note that the rail with the carriage bolts M6 X 25 (holder for the lighting) must be at the back.
See photograph.
Assembly picture 4
Now mount the lamp holder as follows. Place the connecting plate into the lamp holder (See
picture ) and screw the lamp holder using the screws M5X10 and the washers tightly together.
Screw the lamp protection part to the rear lights on the lamp holder. Use the washers and the nuts
M5. Note that the reversing light must be on the right-hand side. (See picture ) Now remove the
pre-mounted screws and washers for the registration plate holder and screw these to the lamp
holder.
Note: When inserting your own registration plate, you will first need to press out the required
formed parts from the registration plate holder.
Attention!
When inserting of your own number plate you must press out first theshaped parts from the number
plate holder. In the two belt guidance you must now still contrive the small clamping belts.
These belts secure the guidable wheel of the bicycle against rotating. Fasten now the completely
installed bulb holder and secure with the disks and nuts M6. Pay attention to it that the bulb holder
is centrically installed. With the provided cable straps you fasten the lighting cable below the carrier.
13