Meradiso LB -2343 Gebrauchsanweisung Seite 15

Congratulations!
With your purchase you have decided on a high-
quality product. Get to know the product before
you start to use it. Carefully read the following
instructions for use. Use the product only as descri-
bed and only for the given areas of application.
Keep these instructions safe. When passing the
product on to a third party, always make sure that
the documentation is included.
Included in delivery / Parts
description (Fig. A)
1 x Air bed with adjustable buckles (1)
1 x Air bed with non-adjustable buckles (2)
2 x Pillows (3)
1 x Carry bag (4)
2 x Screw-on valve (5)
1 x Ruler (6)
2 x Venting tubes (7)
2 x Repair patches (8)
1 x Instructions for use
Technical data
Dimensions per air bed approx. 195 x 81 x 25
cm (L x W x H)
Dimensions per pillow: approx. 62 x 34 x 12 cm
(L x W x H)
Maximum load per air bed: 140 kg
140
Design air pressure: 0.38 PSI (0.026 bar)
Intended use
This item is designed for a maximum user weight
of 140 kg per air bed, and is exclusively for per-
sonal use for camping and leisure. This product is
not a flotation device, water toy, or item of winter
sports equipment.
Safety information
Warning!
Risk of suffocation for children! Do not allow
children to play unattended with the packaging
material or item.
Risk of injury
• Please use the item exclusively for the purpose
for which it was intended.
• The item may only be used by persons familiar
with the safety information.
• Never use the item close to an open flame or
oven, and keep away from sources of heat.
• The item must not be used in the water or for
swimming! It will not remain on the surface,
nor is it suitable as a flotation device. Salt and
chlorinated water may damage the surface of
the item.
• Please observe the maximum load of 140 kg
per air bed. Exceeding the weight limit may
cause damage to the item as well as impair its
function.
• Please inspect the item for damage or wear and
tear each time before you use it. The item is only
to be used in perfect condition! Do not use the
item in the event of visible or presumed damage.
• Discontinue use if the item can no longer hold
air.
• Do not over-inflate, otherwise the item may
burst.
• Please make sure that only competent persons
use this item.
Avoiding material damage
• Avoid contact with sharp, hot, pointed, or
dangerous objects.
• Do not use the item in water and ensure that
the flocked surface does not become wet.
• Only use the valves with suitable pump
adapters, otherwise there may be damage to
the valves.
• This item reacts strongly to cold and heat. Do
not use the item if the surrounding temperature
drops below 15 °C or rises above 40 °C.
Otherwise this may lead to damage.
• Make sure the valves are closed tightly after
inflating.
Assembling the screw-on
valves (Fig. B)
Each air bed (1) (2) is equipped with a threaded
hole for the valves (5).
GB/MT 15