Electrical Wiring - Riello Rg3 Installations-, Bedienungs- Und Wartungsanleitung

3.4 ELECTRICAL WIRING

WARNING
DO NOT EXCHANGE NEUTRAL WITH PHASE
~
50Hz 230V
PE L N
Safety thermostat
7 pin plug
7 pole socket
D1913
Ignition
electrodes
FLAME CONTROL
To remove the flame control from the burner, loosen screw (A, Fig.
10) and pull to the arrow direction, after removing all components,
the 7 pin plug and earth wire.
In case of disassembly of the flame control, retighten the screw
(A) with a torque wrench setting of 1 –1.2 Nm.
2308
Main switch
T6A
Limit thermostat
Brown
Blue
Black
White
Blue
Burner-earth
NOTES:
– Wires of
(Unless requested otherwise by local standards
and legislation).
– The electrical wiring carried out by the installer
must be in compliance with the rules in force in
the Country.
TESTING
Check the shut-down of the burner by opening
the thermostats and the lock-out by darkening
the flame sensor.
Hour counter
(230V - 0.1A max.)
Remote lock-out signal
(230V - 0.5A max.)
Flame sensor
Oil valve
Capacitor
Motor
4 GB
2
min. 1 mm section.
Fig. 10
S7072
A