Boiler Fixing; Fuel Supply - Riello Rg3 Installations-, Bedienungs- Und Wartungsanleitung

3. INSTALLATION
THE BURNER MUST BE INSTALLED IN CONFORMITY WITH LEGISLATION AND LOCAL STANDARDS.

3.1 BOILER FIXING

Put on the flange (1) the screw and two nuts, (see Fig. 3).
–
Widen, if necessary, the insulating gasket holes (4).
–
Fix the flange (1) to the boiler door (3) using screws (5) and (if necessary) the nuts (2) interposing the
–
insulating gasket (4), (see Fig. 2).
After installation ensure that burner is lightly inclined as in Fig. 4.
–
Fig. 2
Fig. 3

3.2 FUEL SUPPLY

T h e b u r n e r i s d e s i g n e d t o a l l o w e n t r y o f t h e o i l s u p p l y p i p e s o n e i t h e r s i d e .
Depending on the oil supply pipes position (to the right or to the left hand side of the burner) the fixing plate
(1) and closing plate (2) should be reversed, (see Fig. 5).
1
2308
Fig. 5
2 2
D5542
2 GB
D5025
Fig. 4
S7071
1