Medion MD 81209 Bedienungsanleitung Seite 50

MD 81209 manual DE_GB_FR_IT_ES.book Seite 24 Montag, 27. Februar 2006 10:33 10
red operating LED will light up.
Selecting a channel
Check that the receiver is set to the same channel (A/B/C/
D) as the transmitter.
Selecting the source
If you have connected two devices to the transmitter, you
can now use the SOURCE 1/2 switch to switch between the
receiver of the first (Source 1) and the second (Source 2)
device.
• To do this, keep the SOURCE 1/2 button at the top of the
receiver pressed down for around 10 seconds, until the
device switches over.
• You can also press down any button on the remote control
belonging to a device that is connected to the transmitter
for 10 seconds, and it will switch devices.
Setting up
• Place the receiver on a sturdy surface.
• Position the receiver so that the front with the LED
operating indicator is facing you.
• If you are using the remote control from the audio/video
source, point it towards the receiver.
• Open up the transmitter aerial and align it with the
transmitter until you have the optimal image.
24