Merax MS304750 Benutzerhandbuch Seite 20

Step 7
Take out the A-1# Console and A-2# console fixed base, remove the pre-attached screw set A-3#.
Please do as below: Insert the A-2# console fixed base into the handlebar and tighten it with L-2#
Combination wrench. Insert the console into the console fixed base.
Get two batteries and place them into the battery slot under the console cover.
The whole bike is completely assembled.
Please use it after careful inspection.
Handlebar/Seat Height Adjustment
You can adjust the handlebar height and seat height with the
Adjustment Handles according to your sitting posture which can make
you feel more comfortable.
Note: Please don't exceed the STOP mark when adjusting the
height of the handlebar post.
Saddle Adjustment
You can adjust the distance of the saddle with the Seat Slider Adj Knob
according to your sitting posture which can make you feel more
comfortable. After adjusting to the suitable distance, use the Seat
Slider Adj Knob to tighten the saddle.