CLOCK TIME ADJUSTMENT
" Hold the CLOCK SET button de-
pressed with the tip of a pen or similar
through step ®.
Press the appropriate day select butto
The corresponding lamp will light.
For details, refer to "DAY ADJUST-
MENT".
Notes
@ Whenever the CLOCK
SET button is depressed, the clock is set
back to 0 second of the current minute and the clock begins to
operate again only after the button is released. Therefore, do not
press the button unnecessarily as the clock will lost time.
@ When the CLOCK SET button is released, the upper dot blinks,
and after 30 seconds,
the upper dot stops blinking and the lower
dot blinks.
Dimmer switch
This switch selects the brightness of the timer indicator.
It may be set to BRIGHT during daylight hours and to DIM at night.
If the dots blink
If the dots between the hour and minutes blink quickly, the time and
the timer setting must be reset.
The dots will blink quickly in any of these three conditions:
@ The recorder's POWER
switch is first turned on.
e@ Before
a power
interruption,
power
has been
supplied
to the
recorder for less than 24 hours. (If power is supplied to the recorder
for more than 24 hours before a power interruption, an internal seif-
charging
battery will be charged
and
hold the clock
and
timer
settings for about 10 minutes.)
® Power has been interrupted for more than 10 minutes.
48
Press the H button for hour digits.
At first keep the button depressed to
advance the digits rapidly and then
press and release immediately to
advance the digits. one by one as
the desired hour indication is approached.
Press the 10 MIN and MIN buttons in the
same
manner.
+)
Release the CLOCK SET button ata
time signal from a broadcast or tele-
°
phone.
The clock is now set to maintain the
correct time.
=
DAY ADJUSTMENT
The day select buttons — numbered 1 to7 — should be arranged
from left to right in order. Determine
by yourself which day
corresponds button ''1''. Suppose today is Wednesday and that
you decide that day select button "1" should represent Monday.
When
setting the clock time, press the button
numbered
''3"
while keeping the CLOCK
SET button depressed. The corres-
ponding lamp will light.
a
|
a:
Oo
oO <8
9 9.9
0
1
ee
5
tL) Li
'i a oO
Mon. - Tue.
d. Thur.
Fri.
Sat.
Sun.
When
setting the day the timer is to trigger a recording, press
the button which corresponds to the day the recording is to be
made, while keeping the PROGRAM
button depressed.
At first all the lamps light indicating that the setting is for every-
day. When
one of the day select buttons
is pressed, the lamp
corresponding to the button will remain lit and all the other will
go out.
To change back the setting to everyday, press the same button
again.
The setting must be either for one day or for everyday.
NEXT WEEK
button
When the day the timer should trigger a recordingisa week later
than that day in the present week, press this button.