Getting Started - Ansmann Racing Xmove 2.0 Evo Bedienungsanleitung

Getting Started

1. Make sure the power supply's rocker switch side marked wtih a
circle (O) is pushed in, which is OFF.
2. Attach the banana plugs of your charger's DC power input cable
to the power supply's banana plug jacks. Make sure you put
the positive (+) red cable in the red (+) jack. Make sure you put
the black common or negative (-) cable in the black (-) jack.
NOTICE: Always connect cable polarities correctly.
3. Attach the AC power cord to the power supply. Make sure the
cord plug is full seated in the socket, then connect the AC power
cord to an appropriate power socket.
4. Push in the rocker switch side marked with a vertical line (I)
to power on the power supply and charger. When powered on,
the charger's power indicator LED glows red and the internal
cooling fan turns. When the charger is powered on, a message
will appear on the LCD screen.
Intelligent digital balance charger xMove 2.0 evo
Please use the PSU
above 15V*33A( 500W)
when fully loaded
1. Connect charger to power supply.
2. Connect charger's power supply to power source.
3. Power on the charger's power supply.
4. Make program selections in the charger for battery charging.
5 Connect charger adapters to charger.
6. Connect battery to charger adapters (connect main charging
connectors before connecting cell-balancing connectors,
where used).
7. Start battery charging.
CAUTION: Always power on the charger before connec-
ting a battery to the charger, or damage to the charger
and the battery can result.
5