ANSMANN Racing xMove 2.0 evo Bedienungsanleitung Seite 10

7.3 Lithium batteries (Lilo/LiPo/LiFe)
program
10
Press "Mode/Esc" key to the screen on the left, then press "Enter/
Startkey to enter into the parameter setting menu. You can switched
at the same level menu by" Dec"/" Inc" key. Please refer the
detailed flow chart on the left. When you are willing to alter the
parameter value in the program, press "Enter/Start"key to make it
blink, then change the value with" Dec"/" Inc" key. The value
will be stored by pressing "Enter/Start" key once. Then press "Enter/
Start" key for more than 2 seconds to start the process.
"AUTO charging" this is for individual Lithium battery or some special
battery pack without balance port or cell count. The left side of the
first line shows the type of battery you select at the user setting. The
right side of the first line shows you the mode of charge. The value
on the left side of second line sets a charge current and the value on
the right side of second line sets the cells count of the battery. the
definition of the following screen are all the same.(To know how to
connect,plesase refer picture B)
"Balance charging" this is for 2-6 cells of Lithium battery with
balance port, the battery pack being charged should have the
individual cell connect, and connect it to the individual port at the
right side of charger with a suitable connection cable that fits with
your battery pack. (see picture B)In this mode, the charging process
will be different from ordinary charging mode. the internal processor
of the charger will monitor and control the voltage of each cell of
the battery pack. This can improve the discharging performance of
the battery! EV charger use the optimised calculation to control the
tolerance in the range of +/- 0,01 V!
Fast charging select thismode to finish charging process earlier.
Principle: When the current down to 1/5 of the current you set
during the CV term, itwill stop the process and eliminate the forcible
requirement of the balance precision. (whether it is been connected
to the balance port), the charging capacity may be a bit smaller than
normal charging but the process time will be reduced.
"Storage mode" this is for charging or discharging Lithium battery
not to be used for the time being. In order to reduce the wastage,
you can select this mode to remain the power to 40% to store. The
final voltage are different from the type of the battery, LiIo:3.75 V,
LiPo:3.85V, LiFe:3.3V. This is an intellective program, If the voltage of
battery at its initial stage is over the voltage level to storage, the pro-
gram will start to discharge,and if it is lower, the program will start
to charge automatically. In order to ensure each battery meets the
demand, the individual plug of the battery pack should be connected
to the individual port of charger.
"Discharge mode" theoretically, Lithium battery do not need to
discharge, especially deep-discharge. This feature is to ensure the
power wastage of the Lithium battery over 90%, to avoid the over-
charge of the individual battery, you should connect the balance plug
of the battery to the charger, and the current may not exceed 1C.
Instruction Manual