ANSMANN Racing xMove 2.0 evo Bedienungsanleitung Seite 11

Picture 1
connection diagram
in the balance
charging/storage/
discharge mode
7.3.1 Start to charge/discharge: after
set up the mode menu correctly, press
"Enter/Start" key for more than 2
seconds to start the process.
Intelligent digital balance charger xMove 2.0 evo
This screen shows the number of cells you set up and the processor
detects."R" shows the number of cells found by charger and "S" is
the number of cells selected by you at the previous menu. If both
number are identical you can start charging by press "Enter/Start"
button. If not, press "Mode/Esc" button to go back to previous menu,
then carefully check the number of cells of the battery pack to charge
again. If you selected the AUTO mode or dischargemode, you can
pass over this screen directly.
This screen shows the present situation during charge process. To stop
charging press"Mode/Esc" key once.
As you can see in the sketch on left:
1
for the cells count
2 for the operating mode
• CHG=charging at auto mode, BAL=balance charging mode
• FAS=fast charging, STO=storage mode, DSC=discharge mode
3 elapsed time
4 charge/discharge current
5 charge/discharge voltage of battery
6 capacity of charge/discharge
Picture 2
Individual cell
connection diagram
11