ANSMANN Racing xMove 2.0 evo Bedienungsanleitung Seite 14

7.5 Pb battery program
This is programmed for charging Pb battery with nominal voltage
from 2 to 20V, Pb battery can not be charged rapidly. They can only
deliver relatively lower current compare to their capacity. The optimal
charge current will be 1/10 of the capacity. Please always follow the
instruction supplied by the manufacturer of battery.
7.5.1 charging Pb battery
7.5.2 discharging Pb battery
7.6 save data and load data program
This charger can store/load up to 10 data of batteries, you can call
out the data for the process without setting up the program again.
14
As you can see on left,you can set up the charge current on the left.
The nominal of the second line and voltage of the battery on the right
of the second line.the charge current ranges from 0.1-10.0 A and the
voltage should be matched with the battery being charged.start the
charge process by pressing"Enter/Start" key for more than 2 seconds.
The screen displays the state of charging process. to stop charging
forcibly,press "Mode/Esc" key once.
Set discharge current on the left and final voltage on the right,the
discharge current ranges from 0.1-5.0A and the voltage should be
matched with the battery being discharged. Start the discharge
process by pressing "Enter/Start" key for more than 2 seconds..
The screen displays the current state of discharge.
Instruction Manual