Nimh/Nicd Battery Program - Ansmann Racing Xmove 2.0 Evo Bedienungsanleitung

7.4 NiMH/NiCd battery program

7.4.1 After check all the mode, to start
the process press Enter/Start key for
more than 2 seconds
Ni M H C HARGE A ut
CUR L I M I T 5 . 0A
Mode/ Esc
Ni M H D I SCHARGE
1. 0A 1 1. 5V
Enter
Start
Ni M H C YCLE
DCHG C HG 3
Intelligent digital balance charger xMove 2.0 evo
Ni MH 2 . 0A 7 . 42V
. .
45 00890
CHG 022
>2S
Press "Mode/Esc" key to the screen on the left,then press "Enter/
Start" key to into the submenu. You can switched at the same level
menu to select the mode by " Dec"/" Inc" key. Please refer the
etailed flow chart on the left. When you are willing to alter the para-
meter value in the program, press "Enter/Start" key to make it blink,
then change the value with " Dec"/" Inc" key. the value will be
stored by pressing "Enter/Start" key once. Then press "Enter/Start"
key for more than 2 seconds to start the process. Since the menu of
NiMH are the same as NiCd, there is an example of NiMH only.
"CHARGE" mode the default mode is "AUT". In "AUT"mode, you need
to set the upper limit of charge current to avoid from higher feeding
current that may damage the battery. Because some batteries of low
impedance and small capacity can lead to the higher charge current
by the processor at automatic charge mode. But in "Man" mode, it
will charge the battery with the charge current you set at the display.
Each mode can be switched by pressing start/enter key, when the
current field is blinking, press " Dec"/" Inc" Key for more than
1 second.
DISCHARGE mode the discharge current ranges from0.1A to 5.0A and
the final voltage ranges from 0.1 to 25.0V, the operating method is
similar as Lithium battery. The final voltage of NiMH battery is 1.0V/
cell, and theNiCd is 0.85V/cell, please refer the recommend by the
battery of manufacturer.
CYCLE mode EV can perform 1-5 cycles of DCHG >CHG or CHG>DCHG
continually.You can select i t for the new NI * * battery or the
long-term placement NI * * battery. Please set up carefully, or it will
damage the battery! To set the parameter please follow the previous
charge/discharge menu.
The screen displays the present state of process. To stop it press "
Mode/Esc"key.
Description:
1 the type of battery
2 operating mode
• CHG = charge
• DSC = discharge
• DCHG > CHG or CHG > DCHG = the cycle mode
3 elapsed time
4 charge/discharges current of the battery
5 voltage of the battery pack
6 capacity of charge/discharge
You can inquire the temperature and ∆V jeder z eit abzurufen
continually by press " Dec"/" Inc" key.
13