Warning And Error Messages - Ansmann Racing Xmove 2.0 Evo Bedienungsanleitung

8. Warning and Error Messages

The output is connected to a battery with incorrect polarity.
This will be displayed in case of detecting an interruption of the con-
nection between battery and output or voluntarily disconnecting the
charge lead during the operation of charge or discharge on output.
The voltage of input power drops below the limit.
The voltage of Lithium battery pack was selected incorrectly.Verify the
voltage of battery pack carefully.
There happens the malfunction at the charger circuit by any reason.
The processor detects the voltage is lower than you set at Lithiumpro-
gram.please check the cell count of the battery pack.
The processor detects the voltage is higher than you set at Lithiumpro-
gram.please check the cell count of the battery pack.
The voltage of one of the cell in the Lithium battery pack is too low.
Please check the voltage of the cell one by one.
The voltage of one of the cell in the Lithium battery pack is too high.
please check the voltage of the cell one by one.
There are bad connection at the individual connector. Please check the
connector and cables carefully.
The internal temperature of the unit goes too high.
Cool down the unit.
The processor can not continue to control the feeding current by any
reason. The unit needs to be repaired.
16 Instruction Manual