Cleaning And Maintenance - Schaub Lorenz GSP14SGA++ K Bedienungsanleitung

You can only change a programme when it has run a short period of time.
Otherwise the detergent has dissolved and the dishwater has been drained.
In such a case you must refill the detergent container.
1. Open the door and press the current programme selection for at least 3 seconds.
2. Set the new programme.
3. Close the door.
When you open the door while the appliance is operating, the appliance will stop
operating. The programme icon will stop flashing and you will hear an acoustic signal
once a minute unless you have closed the door. When closing the door again, the
appliance will start operating after 10 seconds.
Later addition of dishes
You can put dishes later in the appliance unless the detergent container has opened.
1. Open the door slightly to stop operation.
2. You can open the door completely after the rotating spray arms stopped
operation.
3. Now you can add dishes.
4. When you close the door, the appliance starts operating after 10 seconds.
End of a programme
When a programme has ended, you will hear an acoustic signal for 8 seconds.
1. Switch off the appliance (ON/OFF button).
2. Turn off the water.
3. Open the door and leave it ajar for a few minutes.
4. CAUTION! When opening the door hot steam may escape.
5. Wait approx. 15 minutes before you take out the dishes. The dishes are still hot
and will break easily.
6. It is normal that the appliance is wet inside.

7. Cleaning and maintenance

1. WARNING! Disconnect the appliance from the mains before you
clean or maintain it.
2. Always keep the appliance clean so that unpleasant odours do not occur.
59