Schaub Lorenz GSP14SGA++ K Bedienungsanleitung Seite 46

Switch on the
appliance.
1. Fill detergent
container (A/B).
2. Check rinse aid level
(C).
Check water softener..
Load the dish racks.
Select a programme.
Start the appliance.
Changing of a
programme.
Later addition of
dishes.
Open the door and switch on the appliance using the
ON/OFF button.
Comp. A: for all wash cycles.
Comp. B: for programmes with pre-
rinse only.
Mechanical indicator C:
Electric indicator* on the control panel.
(For models with water softener
system only.)
Electric indicator* on the control
panel. Some models are not equipped
with an electric indicator. Estimate the
needed amount of water softener in
such a case.
Remove large parts of food-leftovers. Soften burnt food
residue in pans before loading.
Press the programme button. The indicator of the selected
programme goes on..
Close the door and turn on the tap. The appliance will start
operating after approx. 10 seconds.
1. You can only
programme when it has run a
short period of time. Otherwise
the detergent has dissolved and
the dishwater has been drained. In
such a case you must refill the
detergent container.
2. Open the door und and press the
programme button more than 3
seconds. The appliance enters the
standby-mode. Now you can set
the desired programme.
1. Open the door slightly to stop
operation.
2. You can open
completely after the rotating spray
arms stopped operation.
change a
WARNING!
Open the door
carefully as hot
steam can
escape!
the door
46