Filling Of The Water Softener Container - Schaub Lorenz GSP14SGA++ K Bedienungsanleitung

1 0 dH (German water hardness range) corresponds to:
 1.25
0 Clark (British water hardness range)
 1.78
0 fH (French water hardness range)
 0.178 mmol/l.
Manufacturer's setting is H4 (EN 50242).

4.3 Filling of the water softener container

The water softener container is beneath the lower dish rack.
 Only use a water softener (= dishwasher salt) which is suitable for dishwashers.
Other water softeners and salts, especially table salt, will damage the water
softener container.
 The manufacturer shall not guarantee against and is not liable for any damage
caused by an unsuitable water softener.
 Fill the container only shortly before you start a programme, otherwise spilled
residuals of the water softener may remain in the appliance and cause corrosion.
 The control light on the control panel goes off after the first programme.
1. Remove the lower dish-rack and the lid of the water softener container.
2. Put the equipped funnel in the opening and pour approx. 1.5 kg water softener
(=dishwasher salt) in the container.
3. Then fill the container with water. It is normal that a small amount of water will
run out of the container.
4. Close the lid carefully.
5. The control light for the water softener goes off when having filled the container.
6. Start a programme when having filled the container; otherwise the filter, pump or
other main components of the appliance can be damaged. Failure to do so will
expire the guarantee.
48